![]() ![]() ![]() ![]() It's recommended to set Automgen to run at the same frequency as Connect I/O. Depending on the node you are using, configure the I/O addresses as shown on the images below.If it is running on the same computer as Automgen you may use localhost as the server name Insert the Server name or IP address of the machine where Connect I/O is running.Select tcp-ip client driver from the Driver(s) available list and then click on AddĬlick on the previously added tcp-ip client driver and then click on Set parameters On the Project tree, double click on Configuration > Post-processors > PC > I/O drivers.Analog inputs are written to m variables ( WORD) starting at address 200 and analog outputs are read from m variables starting at address 300. Note that these nodes allow only one connection at a time (one client).ĭigital inputs are written to Automgen i variables and digital outputs are read from o variables. Data exchange is done through TCP/IP where Connect I/O is a server and Automgen a client. There are two nodes available for connecting with Automgen, the AUTOMGEN TCP/IP 16D8A (16 digital and 8 analog I/O) and the AUTOMGEN TCP/IP 64D16A (64 digital and 16 analog I/O).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |